Dfreeeze parking heater remote control Instalační příručka stáhnout pdf (Strana 34)

*The information refers to the signals on the dfreeeze

receiver (plug X3).

Preparation of the adapter cable

● Connect the two yellow cable ends with the

supplied butt connectors as shown in the cable

diagram to the right (pin 2).

● Connect the plug X3 as shown in the cable

diagram on the right.

Note the information on page 32 when

preparing the cable.

Connecting the dfreeeze

receiver

● Connect the plug connector with the respective

devices as shown in the system diagram to the

right.

Installation conguration 1 & 2

The installation congurations 1 & 2 describe the

connection of the dfreeeze

receiver to a Webasto parking

heater with W-bus as the only remote control possibility

as well as the combination with buttons or a clock.

Installation cong 1: Stand Alone with button

Any parking heater that is congured as described

below.

Switching output - Pin 3* 12V continuous signal

(e.g. LED button)

Switching input - Pin 4* 12V switching impulse

Installation conguration 2: Stand Alone with

clock

Any parking heater that is congured as described

below.

Switching output - Pin 3* 12V continuous signal

Switching input - Pin 4* 12V continuous signal

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 47 48

Žádné komentáře

Dfreeeze parking heater remote control Instalační příručka Strana 34